Advertisement
OBJ_BUCH-2346-004.book Page 5 Friday, October 21, 2016 11:56 AM
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
Products sold in AUS and NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
Intended Use
The machine is intended for cutting, roughing and brushing of
metal and stone materials without the use of water.
For cutting with bonded abrasives, a special cutting guard
(accessory) must be used.
When cutting in stone, provide for sufficient dust extraction.
With approved sanding tools, the machine can be used for
sanding with sanding discs.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Spindle lock button
2 On/Off switch
3 Auxiliary handle (insulated gripping surface)*
4 Grinder spindle
5 Locking screw for protection guard
6 Protection guard for grinding
7 Mounting flange
8 Grinding wheel*
9 Clamping nut
10 Carbide grinding head*
11 Protection guard for cutting*
12 Cutting disc*
13 Hand guard*
14 Rubber sanding plate*
15 Sanding sheet*
16 Round nut*
17 Cup brush*
18 Cutting guide with dust extraction protection guard *
19 Diamond cutting disc*
20 Handle (insulated gripping surface)
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Bosch Power Tools
Technical Data
Angle Grinder
Article number
Rated power input
Rated speed
min
Grinding disc diameter, max.
mm
Thread of grinder spindle
Thread length (max.) of grinder
spindle
mm
Weight according to EPTA-
Procedure 01:2014
Net weight*
Protection class
* measured without protection guard and auxiliary handle
The values given are valid for a nominal voltage [U] of 230 V. For differ-
ent voltages and models for specific countries, these values can vary.
Assembly
Mounting the Protective Devices
Before any work on the machine itself, pull the mains
plug.
Note: After breakage of the grinding disc during operation or
damage to the holding fixtures on the protection guard/power
tool, the machine must promptly be sent to an after-sales ser-
vice agent for maintenance. For addresses, see section "Af-
ter-sales Service and Application Service".
Protection Guard for Grinding
Place the protection guard 6 on the
spindle collar. Adjust the position
of the protection guard 6 to the re-
quirements of the operation. Lock
the protection guard 6 by tighten-
ing the locking screw 5 using a Phil-
lips screwdriver.
Adjust the protection guard 6 in such a manner that
sparking is prevented in the direction of the operator.
Note: The encoding keys on the protection guard 6 ensure
that only a protection guard that fits the machine type can be
mounted.
Protection Guard for Cutting
For cutting with bonded abrasives, always use the pro-
tection guard for cutting 11.
Provide for sufficient dust extraction when cutting
stone.
The protection guard for cutting 11 is mounted in the same
manner as the protection guard for grinding 6.
1 609 92A 3L5 | (21.10.16)
English | 5
TWS 6700
3 601 C75 4..
W
670
-1
12000
100
M 10
17
kg
1.6
kg
1.5
/II
Advertisement
