Adjustment Procedure - Denon AVR-S730H Service Manual

ADJUSTMENT
Adjusting Idling Current
1. Preparation
(1) Prepare a DC voltmeter.
(2) Place the unit under normal usage conditions, away from highly ventilated areas such as next to an
air conditioning machine or electric fan.
The set requires an ambient temperature of 15℃ to 30℃ and standard humidity.
(3) Settings of This Unit
• POWER (Power source switch) STANDBY
• SPEAKER (Speaker terminal) No load
(Do not connect equipment such as speakers or dummy resistors.)

2. Adjustment Procedure

(1) Remove the top cover and turn VR510( (ALL Channel) of the MAIN PCB counterclockwise( c ) as far
as possible.
(2) Connect the DC Voltmeter to the test points.
FRONT-Lch : CN510
FRONT-Rch : CN550
CENTER ch : CN530
SURROUND-Lch : CN520
SURROUND-Rch : CN540
SURROUND-BACK Lch : CN560
SURROUND-BACK Rch : CN570
(3) Connect the power cord to an outlet. Next, press the power button to turn on the power.
(4) Set this unit as follows.
MASTER VOLUME : "---" ( c min.) : turn counterclockwise to the lowest position.
SPEAKER (Speaker terminal) : No load
(Do not connect equipment such as speakers or dummy resistors.)
MODE : MCH STEREO
FUNCTION : DVD
(5) Turn VR510 clockwise ( x ) and adjust the voltage of the test point to "2.0mV ± 0.5mV DC" within 2
minutes.
(6) Check whether the voltage is within the range "2.0mV +2mV/-1mV DC" 10 minutes after adjust-
ment.
(7) Adjust the variable resistance of each channel using the same method.
: VR510
: VR550
: VR530
: VR520
: VR540
: VR560
: VR570
DC Voltmeter
VR550 VR540 VR530
CN550 CN540 CN530
F Rch S Rch C Rch
138
AMP UNIT
VR520 VR510 VR570 VR560
CN520 CN510 CN570 CN560
S Lch F Lch S Back Rch S Back Lch