Paper Specifications; Paper Output Capacity; Paper Storage Environment - Samsung SCX-4520S User Manual

Paper Specifications

Category
Acid content
Caliper
Curl in ream
Cut edge conditions
Fusing compatibility
Grain
Moisture content
Smoothness

Paper Output Capacity

Output Location
Face-down output tray
Face-up output slot

Paper Storage Environment

Paper storage environmental conditions directly affect the feed operation.
Ideally, the machine and paper storage environment should be at or near room
temperature, and not too dry or humid. Remember that paper is hygroscopic; it
absorbs and loses moisture rapidly.
Heat works with humidity to damage paper. Heat causes the moisture in paper to
evaporate, while cold causes it to condense on the sheets. Heating systems and air
conditioners remove most of the humidity from a room. As paper is opened and used,
it loses moisture, causing streaks and smudging. Humid weather or water coolers can
cause the humidity to increase in a room. As paper is opened and used it absorbs any
excess moisture, causing light print and dropouts. Also, as paper loses and gains
moisture it can become distorted. This can cause paper jams.
Care should be taken not to purchase more paper than can be used in a short time
(about 3 months). Paper stored for long periods may experience heat and moisture
extremes, which can cause damage. Planning is important to prevent damage to
large supplies of paper.
Specifications
5.5 pH or lower
0.094 ~ 0.18 mm (3.0 ~ 7.0 mils)
Flat within 5 mm (0.02 in.)
Cut with sharp blades with no visible fray.
Must not scorch, melt, offset or release hazardous
emissions when heated to 200 °C (392 °F) for 0.1
second.
Long grain
4 % ~ 6 % by weight
100 ~ 400 Sheffield
2
150 sheets of 75 g/m
2
1 sheet of 75 g/m bond (20 lb) paper
Capacity
bond (20 lb) paper
S
PECIFICATIONS
F
F.9