Samsung SCX-4520S User Manual page 284

Setting Network Protocols
When you first install the machine, all supported network
protocols are enabled when you turn the machine on. If a
network protocol is enabled, the machine may actively transmit
on the network even when the protocol is not in use. This may
increase network traffic slightly. To eliminate unnecessary
traffic, you can disable unused protocols.
1
Press Menu until you see "Network Setup" on the top line
of the display.
2
Press the scroll button ( or ) until "Config Network"
displays on the bottom line.
3
Press Enter to access the menu.
4
Press the scroll button ( or ) until you see the desired
protocol on the bottom line.
5
Press Enter.
If you selected "TCP/IP," assign a TCP/IP address. For
details, see page D.8.
If you selected "EtherTalk," press the scroll button ( or )
to change the setting to "On" (enable) or "Off" (disable).
This menu is only available when you machine is SCX-
4520S/4720FS.
If you selected "NetWare", set the frame type format. For
details, see page D.10.
6
Press Enter to save the selection.
7
Press Stop/Clear to return to Standby mode.
U Y M
SING OUR ACHINE ON A
D
N D.7
ETWORK