Advertisement
Taking care of your machine
Unscrew the shroud anti
Pull to remove the separator plate.
clockwise and remove.
Tap the separator, shroud and separator plate over a bin to remove any dirt/debris. Using
a dry cloth wipe the remaining dirt /debris from the separator, shroud and separator plate.
Re-fitting the separator plate, shroud plate
Line up and push the
Refit the shroud twisting
separator plate into place.
clockwise to lock
into place.
Twist the separator
Refit the dirt container pushing
anti clockwise to lock
down firmly until it clicks and
into place.
locks into place.
Line up the separator
making sure both
rectangular holes in
the dirt container and
separator line up.
Removing blockages from the TurboTool
Slide the locking ring
Lift and separate
to remove.
the housing.
Removing blockages from the Turbobrush
Switch the vacuum cleaner off and disconnect the power plug from the
electrical outlet.
Lay the Turbobrush on a flat surface and turn over to expose the brushbar.
Using a pair of scissors, cut through any threads or hairs caught around the
brushes and brushbar.
Removing blockages from the hose
Remove the hose from the vacuum cleaner
and telescopic extension tube.
Insert a broom handle or similar blunt
instrument into the hose to remove blockage.
Let's talk technical
Using a pair of scissors,
Line up the tabs on front of
cut any hair or debris free
housing and push together
from around the brushes.
to refit. Slide locking ring
into groove to secure.
To test for a blockage
in the hose, drop a
small ball of paper
into the hose.
The paper will
drop through if
the hose is clear.
Tabs
Advertisement
