Tool Assembly - Milwaukee 9081-20 Operator's Manual

Always lock trigger or remove
battery pack before changing or
removing accessories. Only use
accessories specifically recom-
mended for this tool. Others may
be hazardous.
WARNING!
Use only sockets
accessories specifically designed
for use on impact wrenches and
drivers. Other
accessories might shatter or
break causing injury.
Attaching and Removing Accessories
Cat. No. 9082-20 & 9083-20
These impact wrenchs are intended only
for use with sockets designed for impact
wrenches that have a 3/8" (Cat. No.
9082-20) or 1/2" (Cat. No. 9083-20) square
drive. Other sockets could shatter or break,
causing injury.
1. To attach a socket or other acces-
sory, align the accessory with the
drive shank and push it firmly over the
retaining ring.
2. To remove the accessory, pull the ac-
cessory off the drive shank.

TOOL ASSEMBLY

WARNING!
and other
sockets and
Cat. No. 9081-20
This impact driver is intended for use with
drill and driver bits.
1. To attach an accessory, pull the ring
out and insert the accessory shank
(Fig. 3 & 4). Release the ring (Fig. 5). It
may be necessary to pull the bit out
slightly to engage the holding mecha-
nism.
2. To remove the accessory, pull out the
ring and remove the accessory. Re-
lease the ring.
Fig. 3
Fig. 4
Fig. 5
6