Roberts iStream 3 Manual page 34

Set up UPnP access on a Windows PC - cont.
4. Rotate Tuning until 'Shared media' is highlighted and press
the control to select. The radio will scan for all available UPnP
servers. It may take a few seconds for the radio to complete its
scan. The radio will display '<Empty>' if no UPnP servers are
found.
5. After scanning, select your UPnP server using the Tuning
control. If you allowed automatic connection previously, your
radio should now connect and you may skip to the next page.
If you did not permit automatic connections, your radio will then
normally display 'Unauthorised' at this stage.
6. Your PC may prompt you that there has been a connection
to your UPnP server. Whether prompted or not, in order that
the radio may access the music files, you will need to click the
'Library' tab in WMP 12 and select the 'Stream...' item to open
the 'Media Streaming' window. Select 'Automatically allow devices
to play my media' then select 'Automatically allow all computer
and media devices'.
Alternatively select 'More Streaming options' to enable sharing
on a 'per device' basis.
7. In the 'More streaming options' window, the radio may be listed as
a blocked device. Click on the button shown to select 'Allowed'.
Note: If you are using Microsoft's Windows' firewall software,
this should be correctly configured by WMP 12. If you are using
third party firewall software you may need to manually configure
it to allow your unit and WMP 12 to communicate (see the
'Troubleshooting' section on page 68).
8. On the radio, select the named server again using the Tuning
control. If WMP 12 is now able to communicate with your radio
you will be presented with some media selection options on the
display.
33
Allowing a device to connect to Windows Media Player 12
30
DAB
Music player
Shared media
USB playback
My playlist
Repeat play: Off
Shuffle play: Off
Clear My playlist
Shared media
JENNY: Jenny's music
HOME_PC: Mum's music
7