Saltwater Series - Ranger boats 522VX Owner's Manual

SALTWATER SERIES

Navigation and Anchor Lights
The switch that is labeled "Lights" controls the operation of these lights.
On the first key press, the navigation and anchor will both come on. On
the second key press, the navigation lights turn off and the anchor lights
remain on. On the third press, the anchor lights turn off. The indicator
brightness will dim when the navigation or anchor lights are on.
Aerator System
The switches labeled "Aerator 1", "Aerator 2", and "Aerator Timer"
control the aerator system. Pressing the "Aerator 1" switch turns on
aerator 1. Likewise, pressing the "Aerator 2" switch turns on aerator 2.
The pumps will remain on continuously until their corresponding switch is
pressed again. When the pumps are on, the "Aerator Timer" switch can
be used to start a timed aeration cycle. Pressing the "Aerator Timer"
switch once starts the low aeration cycle of 1 minute on and 2 minutes off.
Pressing the switch a second time starts the medium cycle of 5 minutes
on and 2 minutes off. The third press starts the high aeration cycle of 15
minutes on and 2 minutes off. A fourth press of the switch will turn off the
timer function.
Bilge System
The switch labeled "Auto Bilge" controls the bilge pump system.
Pressing the "Auto Bilge" switch once turns on the bilge pump. Pressing
the switch a second time turns off the pump.
Accessories
There are 4 accessory functions labeled "ACC 1", "ACC 2", "ACC 3"
and "ACC 4". Pressing the corresponding switch once will turn on that
accessory. Pressing the same switch again will turn off that accessory.
Horn
Press and hold for operation and release to stop
Back Lighting
The back lighting will turn on for 60 seconds when any key is pressed
and the ignition is in the off position. The back lighting is on when the
ignition is in the on position.
Circuit Breaker Protection
Each function is protected with a circuit breaker. If the circuit breaker
trips, or there is a malfunction with the relay which results in a lack of
power at the output pin of the box, then the corresponding indicator will
flash quickly.
Electrical System
52