Ranger boats 522VX Owner's Manual page 31

5. Apply one coat, being sure to cover and fill all sand marks and thin
spots.
6. Flush gun and let gel-coat set approximately 10 minutes.
7. Repeat step #4, this time adding wax solution approximately 4 ounces
of solution to a quart of gel-coat, then repeat step #5.
8. Let set approximately 8 hours or until dry and tack free.
9. Wet sand with #600 grit WET sandpaper and buff with light buffing
compound.
NOTICE
!
You should contact your Ranger dealer for more information.
Your Boat's Finish
Do not sand metalflake surfaces. A different
procedure is used to repair these finishes.
31