Table of Contents
Advertisement
6. PROCEDURES FOR CONVERTER
OPERATION
The converter incorporates a microprocessor and has automatic cleaning, automatic
zerocalibration, and self-diagnostic functions as well as turbidity measuring functions.
The operator may use the control panel to enable display of various date, manual operation of
solenoid valves, etc., or entry of operation parameters.
This chapter describes key operation procedures, details of indications on the display, etc.
6.1 Components of Control Panel and Their
Functions and Actions
Access to all function in obtained through keys on the control panel. The panel includes display
areas for data, modes, function codes, etc. in which measured values and operating statuses are
displayed.
Figure 6.1 and Table 6.1 show the control panel components and their functions.
(3) Mode indication
area
(8) Status
indication area
(9) Mode key
(11) Data set
keys
Figure 6.1 Control Panel
<6. PROCEDURES FOR CONVERTER OPERATION>
(5) <FAIL> indication
(6) Operation
indication area 1
FAIL
LAMP
MEAS.
MAINT
PROGRAM 1
PROGRAM 2
MODE
MANUAL OPERATION
(12) Valve operation keys
(1) Data display
(7) Operation indication area 2
AMG1 AMG2 AMG3 SV1 SV2 SV3 SV4
mg/l
FTU
nA
mA
V
%
FUNC
HOLD CAL WASH
DATA SET
>
<
ENT
FUNC
SV 1
SV 2
SV 3
SV 4
(4) Unit indication
area
(2) Function code
display area
(10) Function key
F0601.ai
IM 12E04A02-02E
9th Edition : Mar. 16, 2018-00
6-1
Advertisement
Table of Contents
