Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Molift MOVER 205
Summary of Contents for Molift MOVER 205
- Page 1 BM05101 Molift Mover 205...
-
Page 2: Table Of Contents
Quick release suspensions ....... 16 Supporting arms ........16 Castor with directional lock ....... 16 Molift Stretcher .......... 17 Integrated charger ........17 Chassis Low base ........17 Page 2 of 24 BM05101 Molift Mover 205 English - Rev. J/ 10/2012... -
Page 3: General Advice
General advice Responsibility Please read these operating instructions carefully This user manual contains important safety in- before putting the product into operation. We as- structions and information regarding the use of sume no liability for damage or malfunctions re- the lifter. Carefully read the manual before using sulting from failure to comply with the instruc- the lifter in order to be familiar in the function and tions. -
Page 4: Safety Precautions
-equipment must not be removed, disabled or anyone. in any other way altered. A Molift Mover 205 shall only be used when all safety devices and equip- The Molift Mover 205 has a Safe Working ment is in place and fully operational.Portable... -
Page 5: About The Product
Molift Mover 205 is a mobile lifter intended for lift- tach the sling. The suspension rotates freely, allow- ing and transferring persons to/from bed, floor, ing the Molift Mover 205 to be used at any angle. chair or similar, wheelchair and toilet. The lifter is Safety devices made out of light-weight materials, has castors and is powered by a battery. -
Page 6: Technical Data
Type 2215MV 10-22 cells NiCd/NiMH Protection*: tres. IP24 Number of lifts with fully charged battery: 75 lifts (75 kg, 50 cm) SWL (Safe Working Load): 205 kg Lifting range: 1395 mm (center suspension) Lifting speed: 40 mm/sec Rev. Description: Page 6 of 24 BM05101 Molift Mover 205 English - Rev. J/ 10/2012... -
Page 7: Assembly / Disassembly
• Make sure that the red arrow on the lower part of the column corresponds with the edge on To be able to operate the Molift Mover 205, the op- the chassis. Fix the column with the lock han- erator must have good knowledge of the lift, in- dle. -
Page 8: Checklist Before Use
Molift Mover 205 is supplied with a battery with a 26,4 V cell unit that is placed in the battery hold- The lifters electronic system will be active as er on the lift. A battery charger is also supplied to long as the battery is connected. It is therefore... -
Page 9: Battery Capacity
If the battery is discharged during a lift, it is Emergency lowering always enough power to lower the user down again. It is possible to perform an emergency lowering Battery in case of a general malfunction. Molift Mover 205 has both an electrical and manual emergency low- Battery LED ering. Electrical Servicelamp... -
Page 10: Lift And Transfer
Using lifting slings tened to avoid the user slipping or falling. The Molift lifting slings are easy to use. Please see the user manual that comes with the sling for spe- cific instructions. It is recommended to use Molift Easy slings. Slings from other manufacturers may have other specifications leading to unexpected in- stability and possible injury to personnel. -
Page 11: Lift And Movement To And From Bed
Pull the leg loops forward and under the thighs as shown. Fold the sling as indicated above before use. The grey side should be facing away from the user Cross the loops, one through the other. when putting the sling in place. The sling should be held by one hand, leaving the other free to move and support the user. -
Page 12: Lift And Transfer To And From Floor
If possible, lower the bed before lifting. Move the lifter away from bed. Beware of obstructions under the bed that can cause castors to stop or tip Page 12 of 24 BM05101 Molift Mover 205 English - Rev. J/ 10/2012... -
Page 13: Lift And Transfer To And From (Wheel)Chair
Lift and transfer to and from (wheel)chair Place the sling as if in bed. Gently position the lift- ing column between the legs of the user as shown Lift and transfer from (wheel)chair above. The suspension shall be centred over the user. -
Page 14: Bathing
• pull the loop on the back of the sling • tilt the chair slightly backwards Lower the user into chair, unhook sling from sus- pension and remove the lifter. Page 14 of 24 BM05101 Molift Mover 205 English - Rev. J/ 10/2012... -
Page 15: Toileting
Toileting By pulling the leg sections from the inside and out, you will achieve a wider leg position. The Molift Easy Toilet Sling is used with the stand- ard 4-point suspensions. On Molift Easy Toilet Comfort, place the leg section over and down between the thighs and pull out- Molift Easy Toilet sling is a toilet sling with a wards from the inner part of the thighs. -
Page 16: Equipment
Replace the complete column according to As- lease as you change to any other suspension. sembly instructions on page 7. Read the operating manual that comes to- gether with the Supporting arms Page 16 of 24 BM05101 Molift Mover 205 English - Rev. J/ 10/2012... -
Page 17: Molift Stretcher
Molift Stretcher Chassis Low base • Molift Stretcher (excl loops), Part. no: 2150103 - Part no 1420002 Standard set of lifting loops, Part no: 2150357 The chassis can be replaced with one with low- Set of auto strap collector, Part no: 2150356 er legs. -
Page 18: Accessories
One size Art.nr 3047000 Shell lining Part no 3047010 One size Art.nr 3047001 Wool lining Part no 3074011 One size Art.nr 3047002 Fleece lining Part no 3047012 Page 18 of 24 BM05101 Molift Mover 205 English - Rev. J/ 10/2012... -
Page 19: Maintenance
Maintenance Sling size guide Daily maintenance Detergents must be pH-neutral. Do not use solvents or strong liquids - this may damage surfaces on the lifter and change the quality of the material. For disinfection when needed; use isopropyl alcohol. Avoid abrasive or etch- ing cleaning products. Easy and Basic Slings Clean surfaces with a damp cloth using an appro- priate detergent. Recomm. Color Size weight code (cm) (cm) (cm) Make sure that there is no damage or cracks (Kg) -
Page 20: Service
Service Troubleshooting Molift Mover 205 has a LED on the battery holder If you have access to other similar lifters, it might indicating if the lifter needs service. The LED gives be an advantage to “switch parts” in order to locate a green light when the lifter is ready for use. -
Page 21: Labelling
Labelling If the lifter is run up and down constantly for a longer period, the electronics may be overheated The main label is placed on the column below the and the lifter will stop. Wait until the lifter is cooled battery holder. -
Page 22: Checklist For Periodic Inspection
Checklist for periodic inspection Page 22 of 24 BM05101 Molift Mover 205 English - Rev. J/ 10/2012...
Need help?
Do you have a question about the MOVER 205 and is the answer not in the manual?
Questions and answers