Display; Monitor:card - HP E1351A User Manual

DISPlay

Subsystem Syntax

:MONitor:CARD

Parameters
Comments
Example
58 HP E1351A/53A 16-Channel FET Multiplexer Command Reference
The subsystem monitors the channel state of a selected module (or
DISPlay
card). This command can only be used when the FET multiplexer module
is used in a switchbox configuration. It operates with mainframes that have
a display, such as the HP 75000 Series B Mainframe (HP Model Number
E1301). It also operates with terminals connected to the serial interface port.
DISPlay
:MONitor
:CARD < number
[:STATe] < mode
DISPlay:MONitor:CARD <
switchbox to be monitored.
Parameter Name Parameter Type
number
| AUTO
•
Selecting a Specific Module to be Monitored: Send the card
number in a switchbox with the
•
Selecting the Present Module to be Monitored: Use the
DISPlay:MONitor:CARD AUTO
addressed by a switching command (e.g.,
•
*RST Condition:
Select Module #2 in a Switchbox for Monitoring
DISP:MON:CARD 2
| AUTO>
>
number selects the module in a
| AUTO>
Numeric
DISPlay:MONitor:CARD
command to select the last module
[ROUTe:]CLOSe
DISPlay:MONitor:CARD AUTO
Selects module #2 in a switchbox.
Range of Values
1 - 99
command.
).
Chapter 5