Appendix C.hp E1351A/53A Fet Multiplexer Error Messages - HP E1351A User Manual

s
HP E1351A/53A FET Multiplexer Error
No. Title
–211 Trigger Ignored
–213 INIT Ignored
–224 Illegal Parameter Value
1500 External Trigger Source Already
Allocated
2000 Invalid Card Number
2001 Invalid Channel Number
2006 Command Not Supported On
This Card
2008 Scan List Not Initialized
2009 Too Many Channels in Channel
List
2010 Scan Mode Not Allowed On
Thi Card.
2011 Empty Channel List
2012 Invalid Channel Range
2017 Incorrect ARM:COUNt
2600 Function Not Supported On
This Card
2601 Channel List Required
Appendix C
Table C-1 lists the error messages associated with the multiplexer modules
programmed with SCPI commands. See the HP E1406A Command Module
User's Manual for complete information on error messages.
Table C-1. 16-Channel FET Multiplexer Error Messages
Trigger received when scan not enabled. Trigger received after scan
complete. Trigger too fast.
Attempting to execute an INIT command when a scan is already in
progress.
Attempting to execute a command with a parameter not applicable to the
command.
Assigning an external trigger source to a switchbox when the trigger
source has already been assigned to another switchbox.
Addressing a module (card) in a switchbox that is not part of the
switchbox.
Attempting to address a channel of a module in a switchbox that is not
supported by the module (for example, ch. 99 of multiplexer module).
Sending a command to a module (card) in a switchbox that is
unsupported by the module.
Executing a Scan without the INIT command.
Attempting to address more channels than available in the switchbox.
Attempting to execute a SCAN:MODE which is not supported.
No valid channels in
Invalid channel(s) specified in SCAN <
Attempting to begin scanning when no valid channel list is defined.
Attempting to run a downloaded scan list with ARM:COUNt set to value
other than 1.
Sending a command to a module (card) in a switchbox that is not
supported by the module or switchbox.
Sending a command requiring a channel list without the channel list.
HP E1351A/53A FET Multiplexer Error Messages 99
Potential Causes
<channel_list>
.
channel_list>
Appendix C
Messages
command.