Advertisement
Miniexcavators – Undercarriages - Minidumpers – Skid Steer Loaders – Aerial Platforms
ATTENTION: THIS BOOKLET DOESN'T SUBSTITUTE THE OPERATION AND MAINTENANCE
MANUAL. IT'S NECESSARY TO READ CAREFULLY AND UNDERSTAND THE OPERATION AND
MAINTENANCE MANUAL BEFORE CARRYING OUT ANY MANOEUVRE WITH THE MACHINE.
QUICK INSTRUCTIONS FOR HINOWA LIGHTLIFT 15.70 & 13.70 PERFORMANCE
1
st
CYLINDER
LEFT TRACK
AUTOMATIC
OUTRIGGERS
RETRACTION
DISPLAY
STABILIZERS
MANUAL OPERATING
AUTOMATIC
STABILIZATION
PERMISSION OF AERIAL
PART OPERATION FROM
GROUND
To start the machine battery cutter and main
key must be turned ON, than the remote control
emergency STOP button must be pressed and
released, as reminded by the icon here on the
right side. While all the emergency stop buttons
are released, engine or electric motor could be
ignited by pressing the relevant buttons on the
remote control (see picture above).
MAIN KEY
BASKET
2
nd
ROTATION
CYLINDER
(ONLY
LL15.70)
EXTENSION
UNDERCARRIAGE
CLOSING (IF
AVAILABLE)
UNDERCARRIAGE
WIDENING (IF
AVAILABLE)
FIPE131521701
GRAVITY
JIB
EMERGENCY
DESCENT
GASOLINE
ENGINE
WARM UP
EMERGENCY STOP
BUTTON
TURRET
RIGHT
ROTATION
TRACK
SERVICE
MENU
SELECTOR
BASKET
LEVELING
KEY
ENGINE SPEED
SELECTOR
ELECTRIC
THERMIC
MOTOR
ENGINE
(START-
(START-
STOP)
STOP)
PRESS AND RELEASE
REMOTE CONTROL
EMERGENCY STOP
BUTTON
Advertisement
Table of Contents
Related Manuals for Hinowa LIGHTLIFT 15.70 PERFORMANCE
Summary of Contents for Hinowa LIGHTLIFT 15.70 PERFORMANCE
- Page 1 ATTENTION: THIS BOOKLET DOESN'T SUBSTITUTE THE OPERATION AND MAINTENANCE MANUAL. IT’S NECESSARY TO READ CAREFULLY AND UNDERSTAND THE OPERATION AND MAINTENANCE MANUAL BEFORE CARRYING OUT ANY MANOEUVRE WITH THE MACHINE. QUICK INSTRUCTIONS FOR HINOWA LIGHTLIFT 15.70 & 13.70 PERFORMANCE BASKET GRAVITY...
- Page 2 Note1: On gasoline machine when the engine is cold, once it’s ignited, it’s possible to warm it up pressing the “WARM UP” button on the remote control, engine will run faster for 20 seconds. TRACKS MOVEMENTS All the outriggers must be raised from the ground to move the tracks, otherwise the icon here on the left side will be displayed.
- Page 3 shown by the example that follows. The stabilization is the necessary condition to allow aerial part movements. AUTOSTAB AUTOSTAB WAIT WAIT ST1 NO GND ST1 GND ST2 NO GND ST2 GND ST3 NO GND ST3 GND ST4 NO GND ST4 GND AUTS AUTS STEP: 1...
- Page 4 After work is finished close carefully and completely all the arms and perfectly align the turret looking at the yellow arrows. Than the outriggers could be lifted and the tracks moved. LIST OF DISPLAY ICONS Tracks’ maximum speed Insert the controller into its Battery place and stabilize...
Need help?
Do you have a question about the LIGHTLIFT 15.70 PERFORMANCE and is the answer not in the manual?
Questions and answers