Chapter 3 Advanced Usage
7
Press the Up/Down buttons (
8
Press the Up/Down buttons (
9
The N10/N100 will restart. Wait until the home screen is displayed.
10
When the home screen is displayed, disconnect the USB drive.
Checking for Updates Automatically
The N10/N100 can check if newer firmware is released when turning on the N10/N100. If new firmware is detected,
you can continue to update the firmware. It is enabled by default. To disable checking for firmware releases
automatically, follow the procedure below.
1
Press the Menu/Enter button (
2
Press the Up/Down buttons (
) and select "USB", then press the Menu/Enter button (
) and select "OK", then press the Menu/Enter button (
) to display the menu list at the home screen.
) and select "System Update", then press the Menu/Enter button (
45
).
).
).