Samsung M6000 Series User Manual page 77

10. Use the Format command to format the new partitions, and then
11. Remove the startup disk and turn off your computer.
12. Do one of the following to reinstall your applications:
Samsung M6000 User's Manual
2. Turn off the computer, remove your old hard drive, and insert
the new one into your computer. (See "Using the Hard Drive"
on page 33 for instructions.)
3. If you have a CD-ROM drive, install the CD-ROM drive in the
SmartBay and attach the floppy drive to the external floppy
connector. (See "Using the SmartBay" on page 26 and see
"Connecting the Floppy Drive to the Floppy Connector" on
page 24 for instructions.)
4. Under the Boot menu in System Setup, set Diskette Drive as the
first boot device and CD-ROM Drive as the second. (see "Using
System Setup" for information on setting options.)
5. Insert the bootable disk into the floppy drive and start your
computer.
6. After your system boots, remove the startup disk from the
floppy drive and insert the PHDISK disk.
7. At the A: prompt, type:
phdisk /c 266240 /p
and then press <Enter>.
PHDISK automatically creates a save to disk partition of the
maximum size for your computer.
When the save to disk partition has been created, the following
message appears:
Save to disk partition created
successfully
8. Remove the PHDISK floppy disk from the floppy drive and
insert the startup disk.
9. Use the FDISK utility in DOS to create user partitions on your
drive, and then restart your computer. Be careful not to delete
the non-DOS partition that you just created with PHDISK.
restart your computer.
Creating a Save to Disk Partition 66