Safety Instructions; General Notes; Safety Instructions - Operation And Maintenance - UVP GelDoc-It TS3 Installation And User Instructions Manual

TS3
GelDoc-It and ChemiDoc-It
2.0

Safety Instructions

2.1

General Notes

For your own safety, please read this chapter carefully before operating. Observe all safety notes listed in
this user manual.
Symbols and signal words used
The user manual uses the following symbols and signal words to indicate safety hazards or warnings.
General warning
Safety Instructions – Operation and Maintenance
2.2
The system is designed for function, reliability, and safety. The unit may include shortwave UV, which is a
powerful source of UV radiation that will cause damage to unprotected eyes and skin.
For your own safety observe the following notes:

The device must only be operated if all protective equipment is present, and the system is
properly installed and fully functional.

Free access to the power plug and main power switch on the back of the unit must be ensured.

Disconnect the power supply before servicing the system

For UV protection and to extend the life of the UV transilluminator, the system incorporates a
customizable transilluminator shutoff timer built into the software. For additional information,
refer to Touch Screen Interface in this manual.
Caution: Do not override the UV safety switch located on the darkroom without the use of
protective equipment and face shields.
Caution: Shortwave UV (254 nm) is a powerful source of UV radiation that will cause
damage to unprotected eyes and skin. Before operating any unit, ensure all personnel in
the area are properly protected and that instructions for use of this equipment are followed.
TS3
Imagers
Caution: ultraviolet radiation
5
81-0360-01 Rev B