Advertisement
Sport Bar Covers - Installation Instructions
15
15
Re-Install Door Surround
(soft top only)
Re-install the left and right Door Surrounds. Insert the pin in the bottom of the Door Surround into the hole in the belt rail
behind the door. Press the channels along the top of the Door Surround around the horizontal sport bar, above the door
opening. Insert two knobs into the Door Surround and tighten them down.
Door Surround
Insert Pin into hole
in belt rail
Front
Driver's Side Shown
Rev. B 1106
Re-Install Bows Into Pivot Knuckle Assemblies
14
(soft top only)
Re-Install the Side Bow Pivot Knuckles onto the
upper flange of the Pivot Bracket. Align the
knuckle with the bracket and it will snap into
place on the bracket. Install a Pivot Knuckle
Screw and tighten with T-30 Torx driver.
Re-Install the Rear Bow Pivot Knuckle
Assemblies onto the lower flange of the
Pivot Bracket. Make sure that the holes
in the Pivot Knuckles are facing the
outside of the vehicle. Align the knuckle
with the bracket and it will snap into place
on the bracket. Install a Pivot Knuckle
Screw and tighten with
T-30 Torx driver.
14
NOTE:
The TJD Wrangler Unlimited will only have One Flange and Side Bow Pivot Knuckle
Front
Driver's Side Shown
of TJ Wrangler
Door Surround
Knob
Channels
View from inside
above Driver's Side
Side Bow Pivot
Knuckle - snap into
place on bracket
Pivot Knuckle
Screws
Rear Bow Pivot
Knuckle - snap into
place on bracket
Front
Knob
80022 / 80023 pg. 6
Advertisement
