Advertisement
Sport Bar Covers - Installation Instructions
Parts List
Sport Bar Cover
Horizontal Sport Bar Covers
Lower Soft Top
If your vehicle has a soft top, release the top
from the windshield and lay the top and bows
down on the tailgate.
Use a T-30 Torx driver to remove the Pivot
Knuckle Screws that attach the Side Bow and
Rear Bows to the brackets on each side of the
vehicle. Push down on each bow to pop it loose
from the bracket.
Leave the bows and fabric laying on the tailgate.
Remove Pivot
Knuckle Screws
Rear Bow
Pivot Knuckle
Front
Driver's Side Shown
Rev. B 1106
Qty - 1
Qty - 2
Side Bow
Remove Speaker Pods
Pivot Knuckle
Use the #30 Torx to remove the bolts on the speaker pods.
Pull the pods out slightly to expose the wiring inside. Release
these wires by lifting up the tab on the connector. The speaker
pods can be removed and set aside for later.
Front seat
belt casing
The installation of the Sport Bar Covers will be
easier if the door molding is removed. To remove
the door molding, unscrew the knobs above the
door opening and lift the molding off of the vehicle.
Door Molding
Remove #30 Torx Bolts
Remove Existing
Sport Bar Covers
If your vehicle has sport bar
covers, you must cut them
off before beginning this
installation. The casing
around the front seat belts
can be pulled out slightly to
remove the fabric under it.
Remove Door Molding
Knobs
Connector
Pod
Tab
80022 / 80023 pg. 2
Advertisement
