Advertisement
Quick Links
Installation Instructions
Sport Bar Covers
www.Bestop.com
- We're here to help! Visit our web site and click on
INSTALLATION TIME
1 Hour
TOOLS
DO NOT remove seat belts for installation.
Manufacturer's warranty will be compromised.
SKILL LEVEL
1 - Easy
Socket
Vehicle Application
•Jeep TJ Wrangler
2003 -2006
Part Number: 80022
"Ask a Question"
Click here for more
sport bar covers
•Jeep TJD Wrangler Unlimited
2004 -2006
Part Number: 80023
Jeep
Accessories by Bestop.
®
Advertisement
Summary of Contents for Bestop Sport Bar Covers
- Page 1 Vehicle Application Installation Instructions •Jeep TJ Wrangler •Jeep TJD Wrangler Unlimited Sport Bar Covers 2003 -2006 2004 -2006 Part Number: 80022 Part Number: 80023 www.Bestop.com - We’re here to help! Visit our web site and click on “Ask a Question”...
- Page 2 Push down on each bow to pop it loose from the bracket. The installation of the Sport Bar Covers will be Leave the bows and fabric laying on the tailgate. easier if the door molding is removed. To remove the door molding, unscrew the knobs above the door opening and lift the molding off of the vehicle.
- Page 3 Orient the entire fabric assembly over the Vehicle’s Sport Bars with the zippers towards the underside of the bars. The Bestop ® label should be on the rear leg of the passenger’s side and there should be some pre-cut openings for the seat belts and the speaker pods.
- Page 4 Sport Bar Covers - Installation Instructions Install Sport Bar Cover Snap Flap to Rear Legs The zippers for the center, side and rear bar Drape the cover over the Rear Sport Bar and should all intersect above the front seat belts.
- Page 5 Sport Bar Covers - Installation Instructions Re-Install Speaker Pods Re-Install the Speaker Pods onto the new Sport Bar Cover. The pre-cut holes should expose placement of the speaker rod and wiring on the center bar, and placement of the bolts on the upper leg. Re-connect the wiring and tighten the bolts down again with the #30 Torx.
- Page 6 Sport Bar Covers - Installation Instructions Re-Install Bows Into Pivot Knuckle Assemblies (soft top only) Re-Install the Side Bow Pivot Knuckles onto the upper flange of the Pivot Bracket. Align the Side Bow Pivot knuckle with the bracket and it will snap into Knuckle - snap into place on the bracket.
- Page 7 Your covers are made of the finest materials available. To keep it looking new and for the maximum possible wear, it will need periodic cleaning and maintenance. Washing: The fabric should be washed often using soap, warm water and a soft bristle brush. Rinse with clear water to remove all traces of soap or use Bestop -recommended Bestop Cleaner and Bestop Protectant.