Advertisement
Sport Bar Covers - Installation Instructions
13
Install Horizontal Bar Cover
13
Locate a Horizontal Bar Cover in the parts kit and orient it with the openings in the cover over the mounting holes for the Door Surround. Wrap the cover
around the bar and close the zipper from front to back. Slide the cover around the bar so that the zipper is along the inside of the bar and the openings
are clear to accept the Door Surround.
Repeat this procedure on the other side of the vehicle.
Rev. B 1106
12
12
Re-Install the Speaker Pods onto the new Sport Bar Cover. The pre-cut holes should
expose placement of the speaker rod and wiring on the center bar, and placement of
the bolts on the upper leg. Re-connect the wiring and tighten the bolts down again with
the #30 Torx.
Front
Place openings in cover over holes
for mounting Door Surrounds
View from Outside
Passenger Side
Re-Install Speaker Pods
Re-connect Wiring
Bolt Speaker
Down
Rear
View from Inside Passenger Side
Speaker Pods Should cover
NOTE
pre-cut holes completely
Slide Cover so zipper
is along inside of
Horizontal Bar
Close Zipper
from Front to Back
80022 / 80023 pg. 5
Advertisement
