Starting Up The D-Cine Premiere Dp100; Switching On The Projector - Barco R5976907/00 User Manual

3. STARTING UP THE D-CINE PREMIERE DP100

Overview
•

Switching On the projector

• Starting Image Projection
3.1 Switching On the projector
How to switch On the projector
1. First, carry out the projector check up (see "Check up the D-Cine Premiere DP100", page 5).
2. Press the tumbler switch (A) in the "I" position (ON state indicated by a visible red section of the switch). (image 3-1)
Note: Ensure that the power tumbler switch on the input panel on the projector head is in the ON state
After power On switching, the projector boots up for a while (±30s) and the final status of the projector is as follows: (image 3-2,
image 3-3)
Projector Control Panel (image 3-2)
Lamp Off
Dowser closed
Push button controls
Control panel status
Touch screen panel
Panel lighting
Projector Cooling System
Fans
Engine cooling
Projector Status Lights (image 3-3)
Status lights
R5976907 D-CINE PREMIERE DP100 02/11/2005
Explanation
The lamp is OFF , indicated by the built-in Red LED ON (A).
The dowser is closed, indicated by the built-in Red LED ON (B).
The last pressed button is selected, indicated by the built-in Green LED On (D).
After boot up of the projector without (power) FAILURE detection, the status LED
changes over from Red to Green (C).
The start up menu "HOME" is displayed on the screen (E).
Blue panel lightning is on.
Explanation
All Fans as well the Exhaust are activated, starting the air ventilation in the projector.
The water pump in the cooling circuit is activated, starting the liquid circulation
into the engine and the radiator.
Explanation
While the projector is booting up, the status light will be flashing red.
After boot up of the projector without ERROR detection, the color of the status
Lights (A) are Green. When an error is detected, the color changes to Red.
3. Starting up the D-Cine Premiere DP100
9