Installation Instructions - Electrolux MLTU16*GAWB series Use And Care Manual

Leveling your washer
Excessive noise and vibration can be prevented by properly
leveling the washer.
1. With the washer within 4 feet (1 m) of its fi nal location,
place a level on top of the washer.
2. Use adjustable pliers to adjust the leveling legs so the
washer is level front-to-rear and side-to-side, and stable
corner-to-corner.
3. Press down on alternate corners and sides and feel for the
slightest movement. Adjust the appropriate leg(s) so the
washer sits solidly on the fl oor on ALL four legs. Keep the
leveling leg extension at a minimum for best performance
of the washer.
Connecting inlet water
1. Run some water from the hot and cold faucets to fl ush the
water lines and remove particles that might clog the water
valve screens and to determine which faucet is hot and
which is cold supply.
2. Remove the inlet hoses from plastic bag located in the
drum of the washer. (Actual hoses shipped with the washer
3. Connect the HOT* inlet hose to the HOT inlet connection
on the washer and the COLD inlet hose to the COLD
inlet connection on the washer. Do not cross thread or
over-tighten these connections.
4. Connect the HOT inlet hose to the HOT water supply and
the COLD inlet hose to the COLD water supply.
5. Turn on the water and check for leaks.
*Hot water inlet may not be available on your washer. Use
Cold water inlet only if this is the case.

Installation Instructions

7
a
c
a
c
"C"
(COLD)
e
g
"H"
(HOT)
b
lower
raise
d
b
d
f