Advertisement
Installing the Camera
1
1 -1
Ceiling Installation
a
Wall Installation
a. Template
Attach according to the "SCREW HOLE POSITION" on the template sheet.
Attaching to a junction box
Attach the ceiling plate to the junction box after confirming the fixing holes locations with the
external dimensions diagram.
2
d
❶
M4
Screws (included)
c
c. Safety wire
d. LAN cable
3
5
2
1 -2
b
a
b. Ceiling plate
M4
Screws (included)
4
1
2
e
e. Waterproof packing
f. Zip tie
Attach the waterproof packing while firmly
1
pressing and spreading it so that there
are no gaps.
2
The zip tie is intended for waterproofing,
so ensure that it is tightly fastened. Snip
the base of the protruding portion, so that
the tip of the zip tie is no longer pointed.
6
1
Using the multi-cable (included)
Connect all the cables to the connector on the camera side.
7
When the installation has finished, please
adjust the angle from the camera settings
page (please refer to "Operation Guide").
Installing without using the ceiling plate
Attach according to the "SCREW HOLE
POSITION A" on the template sheet.
2
f
Attaching the sunshade cover
(sold separately)
Rebooting/Resetting the Camera
LED
Reboot switch
M4×4
Screws
(included)
© CANON INC. 2016
g
h
i
When using the composite pipe
The composite pipe (3/4 inch NPSM threaded
hole) can be connected to the connection slot.
Wrap the sealing tape around where the pipe
connects as necessary to prevent rainwater
or other moisture from seeping in, clear away
any debris and then tighten it firmly. Also,
apply silicon sealant or a similar substance
as necessary to seal the pipe tightly after
attachment.
When using the composite pipe, the included
multi-cable cannot be used.
Dedicated wrench
Ceiling pendant mounting
For details please refer to the Installation Guide
included with the Pendant Mounting Kit (sold
separately). After attaching the ceiling plate,
please go to Step 2, and the steps following it,
in these instructions.
Dedicated wrench
Rebooting
To reboot the camera by turning its power off and on,
remove the dome case and press the reboot switch.
Note
Rebooting can be done from the camera settings page as well
(please refer to "Operation Guide").
Resetting
To restore factory settings, follow these steps.
1) Hold the reset switch down, and press the reboot switch
with a pointed object.
Reset switch
2) Keep inclining the reset switch for at least three
seconds, release the reboot switch.
3) After the LED starts to blink, release the reset switch.
When the blinking has stopped, the unit has finished
resetting.
j
k
M3 Screws (included)
g. LAN cable h. Power cable
i. Audio interface cable
j. GND k. I/O interface cable
10 mm (0.39 in.) or more
M3*
* Included
with Pendant
Mounting Kit
M4* × 4
Printed in Japan
Advertisement
