Table of Contents
Advertisement
3-6) ALARM MENU Function setting
•
Function: Allows users to set the ALARM MODE for each camera.
Setting method: Move to #6. ALARM MENU by using ▲/▼ KEY in the SETUP MENU, and
•
press the ENTER SWITCH to display the OSD as shown in the figure below. (The figure shows
the initial setting status.)
06/01/03
ALARM
CAM1
CAM2
CAM3
CAM4
CAM5
CAM6
CAM7
CAM8
HOLD TIME
ALARM ON TIME
ALARM OFF TIME
BUZZER
(1) CAM1 to CAM8 item sets whether the alarm sensor connected to the camera is used or not.
(ON: Alarm function setting, OFF: Alarm function canceling)
(2) HOLD TIME item sets time to freeze alarm operation when alarm occurs.
(HOLD TIME to be set: 05SEC ~ 1MIN ~ 30MIN)
(3) ALARM ON/OFF TIME item sets beginning time (ON) and end time (OFF) that monitor
recognizes as alarm event.
* Note :Even if CAMERA ALARM is set to ON, alarm operation is not carried at time band except
pre-set ALARM ON/OFF TIME.
(4) BUZZER sets whether or not buzzer(high-pitched tone)sounds when an ALARM or
VIDEO LOSS occurs.
[S] - Static IP (41page) ,
13:14:00
SETTING
ON
ON
ON
ON
ON
ON
ON
ON
05SEC
00:00
00:00
ON
(ON: BUZZER operation, OFF: Cancel)
[D] - DHCP (43page) ,
Eng-40
[P] - PPPoE (46page)
Advertisement
Table of Contents
