Samsung SPN4235 Owner's Instructions Manual page 35

How to Set up Your PC Software (Windows only)
The Windows display-settings for a typical computer are shown below. However, the actual screens
on your PC will probably be different, depending upon your particular version of Windows and your
particular video card. But even if your actual screens look different, the same, basic set-up information
will apply in almost all cases. (If not, contact your computer manufacturer or Samsung Dealer.)
68
On the windows screen, select in the following
sequence : Start Settings Control Panel.
When the control panel screen appears, click on
"Display" and a display dialog-box will appear.
Select the "Settings" tab in the display dialog-
box.
The two key variables that apply to the PDP-PC
interface are "resolution" and "colors".
The correct settings for these two variables are:
• Size (sometimes called "resolution")
:640 x 480 pixels.
• Color: "24-bit" color (might also be expre-
ssed as "16 million colors")Shown at left is
a typical screen for "Display" dialog box.
If a vertical-frequency option exists on your
display settings dialog box, the correct value is
"60" or "60 Hz." Otherwise, just click "OK"
and exit the dialog box.
Continued...
Notes:
Both screen position and size will vary, depending on the type of PC monitor and its resolution.
The table below shows all of the display modes that are supported:
Vertical
Video signal Dot X Line
Frequency (Hz)
640 X 350 70.086
85.080
640 X 400 85.080
720 X 400 70.087
85.039
640 X 480 59.940
72.809
75.000
IBM PC / AT
Compatible
85.008
800 X 600 56.250
60.317
72.188
75.000
85.061
1024 X 768 60.004
70.069
75.029
84.997
• The interlace mode is not supported.
• The PDP operates abnormally if a non-standard video format is selected.
Notes:
• When this PDP is used as a PC display, 32-bit color is supported.
• Depending on the manufacturer, your PC display screen might appear different.
(and depending on your particular version of Windows).
Check your PC instruction book for information about connecting your PC to a PDP.
• If a vertical and horizontal frequency-select mode exists, select 60Hz (vertical) and 31.5kHZ
(horizontal).
• In some cases, abnormal signals (such as stripes) might appear on the screen when the PC power
is turned off (or if the PC is disconnected). If so, press the Source button to enter the VIDEO mode.
Also, make sure that the PC is connected.
• Connect only a PC monitor to the monitor output port while viewing the PC screen. (Otherwise,
random signals might appear).
Horizontal Vertical Horizontal
Frequency (KHz) polarity polarity
31.469 N P
37.861 N P
37.861 P N
31.469 P N
37.927 P N
31.469 N N
37.861 N N
37.500 N N
43.269 N N
35.156 N/P N/P
37.879 P P
48.077 P P
46.875 P P
53.674 P P
48.363 N N
56.476 N N
60.023 P P
68.677 P P
69