Connecting Speakers - Samsung SPN4235 Owner's Instructions Manual

Cable with a Cable Box that Descrambles Some (But Not All) Channels
To complete this connection you will need a two-way splitter, an RF (A/B) switch, and four coaxial
cables (which you can buy from your Samsung dealer or any electronics store).
Find and disconnect the cable that is con-
1
nected to the ANTENNA IN terminal of
your cable box.
This terminal might be labeled "ANT IN",
"VHF IN", or simply, "IN". Connect this
cable to a two-way splitter.
Connect a coaxial cable between an OUT-
2
PUT terminal of the splitter and the IN termi-
nal of the cable box.
Connect a coaxial cable between the
3
ANTENNA OUT terminal of the cable box
and the B-IN terminal of the A/B switch.
Connect a coaxial cable between the
4
ANTENNA OUT terminal of the cable box
and the B-IN terminal of the A/B switch.
Connect the last coaxial cable between the
5
OUT terminal of the RF (A/B) switch and
the VHF/UHF terminal on the PDP.
After you've made this connection, set the A/B switch to the "A" position for normal viewing.
Set the A/B switch to the "B" position to view scrambled channels. (When you set the A/B switch
to "B", you will need to tune your Set-Top Box to the cable box's output channel, which is usually
channel 3 or 4.)
22

Connecting Speakers

External speakers are sold seperately. Check with your dealer.
Speaker Audio Cable Speaker Audio Cable
External speakers MUST have a power handling
capability of 10 watts minimum (impedance 8 ohm).
How to Connect
Connect the speaker audio cable to the external speaker output jack on the PDP matching the
"+" and "-" ends of the cable with the diagram on the PDP.
Connecting PDP and Speakers
1 Fix the bracket onto the guide pole located on the rear of speaker and fasten the screws.
2 After removing the three screws on the PDP, clamp the speaker and the PDP together and
fasten the screws.
Guide
pole
Guide
pole
Powered Subwooper
(Option)
Please use the speaker-built in amplified audio.
23