Connecting To A Pc - Samsung SPN4235 Owner's Instructions Manual

Connecting to a PC

Connection to a Macintosh computer may require in adapter.
PDP
or
Use the DVI-D
connection cable.
(sold separately)
DVI Cable PC Cable Audio Cable
DVI jack
(The actual config-
uration on your PC
may be different,
depending on the
model.)
Connecting a PC to the PDP
1 Connect a PC (15pin) cable between the PC Output jack (or DVI jack) on the PC and the
RGB IN(or DVI IN) Input jack (15p D-SUB) on the PDP.
2 Connect a Audio cable between the Audio (RGB or DVI) on the PC and the Audio L/R (RGB
or DVI) input jacks on the PDP.
To watch the PC screen:
1. Turn on your PDP, and press the TV/VIDEO button on the remote control.
2. Press the UP or DOWN button to select "PC", then press the ENTER button.
3. Turn on PC and check for PC system requirements. (Refer to pages 66 and 67
for PC system requirements.)
4. Adjust the PC screen. (Refer to pages 70 and 76.)
66
Power Plug
Ferrite Cores
PC
Pin Configuration
D-Sub Cable
• 15Pin Signal Cable (based on protruded pin)
Setting up Your PDP (Plug and Play)
Our adoption of the new VESA Plug and Play solution eliminates complicated and time consuming
setup. It allows you to install your monitor in a Plug and Play compatible system, without the usual
setup hassles and confusion. Your PC system can easily identify and configure itself for use with your
display. This monitor automatically tells the PC system its Extended Display Identification data (EDID)
using Display Data Channel (DDC) protocols.
DVI-D Cable (Digital-Only Connector)
67