Turning The Compressor On And Off - Invacare HomeFill Oxygen System User Manual

3. With the other hand, grasp the outer ring (sleeve) of
the connector fillport E and push DOWN F.
4. Lift up on the cylinder to remove from the connector
fillport.
5. When the cylinder fillport is disconnected from the
connector fillport, release the outer ring (sleeve) of the
connector fillport and use two hands to remove the
cylinder from the compressor cradle.
WARNING!
– The fillport cover on the connector fillport
and the cylinder fillport MUST be replaced
after filling and whenever not in use. If
either of the fillport covers are missing
contact your healthcare provider before
using.
1100873-M
6. Place the fillport covers onto the connector fillport G
and cylinder fillport H.
When using the post valve type cylinder,
attach an oxygen regulator per manufacturers
instructions.
7. Examine the cylinder gauge to ensure cylinder is full
(needle pointing into GREEN area). If the cylinder is not
full, perform the following:
a. Repeat 4.3 Connecting the Cylinder to the Compressor,
page 19.
b. If cylinder is not full after second attempt to fill,
contact the provider.

4.5 Turning the Compressor On and Off

Usage
21