Inserting The Batteries In The Remote Control; Assembling The Stand-Base - Samsung PS-50P4H Owner's Instructions Manual

Inserting the Batteries in the Remote Control

You must insert or replace the batteries in the remote control when
you:
Purchase the PDP
Find that the remote control is no longer operating
correctly
1
Remove the cover on the rear of the remote control by pressing
the symbol ( ) downwards and then pulling firmly to remove it.
2
Insert two R03, UM4, "AAA" 1.5V or equivalent batteries taking
care to respect the polarities:
- on the battery against - on the remote control
+ on the battery against + on the remote control
3
Replace the cover by aligning it with the base of the remote
control and pressing it back into place.

Assembling the Stand-Base

1
Assemble two support pins with the stand base and firmly secure
both sides of the support pins using 8 screws provided.
2
Assemble the PDP with the stand and firmly secure the PDP using
6 screws provided.
Two or more people should carry the PDP. Never lay the
PDP on the floor because of possible damage to the screen.
Always store the PDP upright.
(depending on your model)
The angle of the PDP can be up to 15
degrees left/right.
ENG
9