Inserting The Batteries In The Remote Control; Assembling The Stand-Base - Samsung PS-42P3ST Owner's Instructions Manual

BN68-00528A-01_ENG 2003.11.20

Inserting the Batteries in the Remote Control

You must insert or replace the batteries in the remote control when
you:
Purchase the PDP
Find that the remote control is no longer operating
correctly
1
Remove the cover on the rear of the remote control by pressing
the symbol downwards and then pulling firmly to remove it.
2 Insert two R03, UM4, "AAA" 1.5V or equivalent batteries taking
care to respect the polarities:
- on the battery against - on the remote control
+ on the battery against + on the remote control
3
Replace the cover by aligning it with the base of the remote
control and pressing it back into place.

Assembling the Stand-Base

Fit the Stand-Base into the guide hole on the bottom of
the monitor and tighten the left and right sides using
four screws for each side.
Two or more people should carry the PDP.
Never lay the PDP on the floor because of
possible damage to the screen. Always store the
PDP upright.
For the details, refer to the user's guide
"How to assemble the PDP stand (SMM4230)"
4:13 PM Page 11
ENG
11