LaserLiner ClampMeter XP Operating Instructions Manual page 20

Current measurement DC/AC
3
!
The test prods and the temperature sensor (K-type) must be disconnected before measuring
AC/DC current.
1.
AC/DC AC/DC
1000
DC current measurement: Switch to DCA measurement without the line to be measured.
!
Allow sufficient time for the display to reset to zero (ZERO). If necessary, DC offsets can be
zeroed with the REL button.
Connection of test prods
4
Black
Contact temperature measurement
5
To measure contact temperature, connect the supplied temperature sensor (K-type) to the device.
Ensure correct polarity.
1.
After switching on, the ambient
temperature is briefly displayed
Frequency and duty factor measurements
6
1.
Frequency and duty
factor measurements
20
EN
2.
AC/DC
500 selection
Red
2.
2.
3.
correct
Place the ClampMeter around one wire
3.
°C/°F
selection
3.
HZ/% Connect the measuring contacts
selection to the object to be tested
incorrect
Black Red