LaserLiner ClampMeter XP Operating Instructions Manual page 17

• The device works with LEDs of risk group RG 0 (exempt, no risk) in accordance with the latest versions
of applicable standards relating to photobiological safety (EN 62471:2008-09ff / IEC/TR 62471:2006-07ff).
• Radiation power: Peak wavelength equals 456 nm. Mean radiance is below the limit values of risk
group RG 0.
• When used for the intended purpose and under reasonably foreseeable conditions, the accessible radiation
of the LEDs is safe for the human eye and skin.
• Temporary, irritating optical effects (e.g. dazzling, flash blindness, afterimages, colour vision impairment)
cannot be completely ruled out, especially under low ambient light conditions.
• Do not intentionally look directly into the radiation source for longer periods of time.
• No specific measures are required to ensure the limit values of risk group RG 0 are maintained.
Safety instructions
Dealing with electromagnetic radiation
• The measuring device complies with electromagnetic compatibility regulations and limits in accordance
with the EMC Directive 2014/30/EU which is covered by the Radio Equipment Directive 2014/53/EU.
• Local operating restrictions - for example, in hospitals, aircraft, petrol stations or in the vicinity of people
with pacemakers - may apply. Electronic devices can potentially cause hazards or interference
or be subject to hazards or interference.
Safety instructions
Dealing with RF radiation
• The measuring device is equipped with a wireless interface.
• The measuring device complies with electromagnetic compatibility and wireless radiation regulations
and limits in accordance with the RED 2014/53/EU.
• Umarex GmbH & Co. KG hereby declares that the ClampMeter XP radio equipment complies
with the essential requirements and other provisions of the European Radio Equipment Directive
2014/53/EU (RED). The EU Declaration of Conformity can be found in its entirety at the following
address: http://laserliner.com/info?an=clmexp
Test prods
With protective cap: CAT III up to max. 1000V / CAT IV up to max. 600V
Measuring contacts
Without protective cap: CAT II up to max. 1000V
ClampMeter XP
17
EN