Advertisement
Quick Links
TimeCutter
Model No. All models
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Note: Determine the left and right sides of the machine from the normal operating position.
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Riding Mower
Description
No parts required
Rear hitch
Bolt (5/16 x 1 inch)
Locknut (5/16 inch)
No parts required
No parts required
No parts required
Ignition key
Hose coupling (not included with CE
models)
Operator's Manual
Engine Operator's Manual
Operator training material
Register at www.Toro.com.
Form No. 3382-314 Rev A
Qty.
–
Connect the battery.
1
2
Install the rear hitch.
2
–
Set up the motion-control levers.
–
Connect the seat hold bar.
–
Check the mower adjustment.
1
1
Complete the setup.
1
1
1
Original Instructions (EN)
All Rights Reserved *3382-314* A
Printed in the USA.
Setup Instructions
Use
Advertisement
Related Manuals for Toro TimeCutter Series
Summary of Contents for Toro TimeCutter Series
- Page 1 Operator's Manual Engine Operator's Manual Operator training material Note: Determine the left and right sides of the machine from the normal operating position. © 2013—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3382-314* A 8111 Lyndale Avenue South Printed in the USA.
- Page 2 Connecting the Battery Installing the Rear Hitch No Parts Required Parts needed for this procedure: Rear hitch Procedure Bolt (5/16 x 1 inch) 1. Locate the battery and negative battery cable. Locknut (5/16 inch) 2. Remove the plastic cap from the negative battery post. 3.
- Page 3 Setting Up the Motion-control Connecting the Seat Hold Bar Levers No Parts Required No Parts Required Procedure Procedure 1. Locate the seat-hold bar on the frame of the machine. 2. Remove the fasteners. 1. Locate the motion-control levers attached, but folded down on the machine.
- Page 4 Checking the Mower Completing the Setup Adjustment Parts needed for this procedure: No Parts Required Ignition key Hose coupling (not included with CE models) Procedure Operator's Manual Engine Operator's Manual Adjust the side-to-side level and the front-to-rear blade slope. Use the relevant procedures in the Operator's Manual to verify Operator training material that the deck is level, and make any adjustments as necessary.
Need help?
Do you have a question about the TimeCutter Series and is the answer not in the manual?
Questions and answers