Advertisement
Installation Instructions
Installing the Cable Clamps
Use the following steps to install the cable clamp brackets, 6 large cable clamps, and 1 small cable clamp. Use the large clamps for
mains and motor cables, and the small clamp for control wiring.
1.
Position the 4 holes in the edge of the extension
bracket over the 4 threaded studs on the drive back-
channel.
2.
Fasten 4 M8 hex nuts (T30), securing the extension
bracket to the studs.
3.
Position the 4 holes in the corners of the cable
bracket over the 4 threaded studs on the front of the
extension bracket.
1
M8 hex nut
2
Threaded stud
3
Extension bracket
4
Cable clamp, 16 mm
5
Cable bracket
Illustration 1.2 Cable Clamp Kit Overview
MI35U102
Cable Clamp Kit for E3h/E4h Drives
®
VLT
FC Series FC 102, FC 103, FC 202, and FC 302
4.
5.
6.
6
7
8
9
10
Danfoss A/S © 04/2018 All rights reserved.
Fasten 4 M6 hex nuts (T25), securing the cable
bracket to the studs.
Tilt each cable clamp at a 45º angle and insert the
hooks through any 2 holes in the bracket. Lower to a
horizontal position.
Insert a cable into each clamp and tighten the cable
adjustment screw to secure the cable.
Clamp adjustment screw
Cable clamp, 60 mm
Threaded stud
M6 hex nut
Key hole
3
Advertisement
