Table of Contents
Advertisement
-
The recommended operating pressure in the hot water circuit is 0.48 MPa. At the hot water discharge
we recommend that a reverse flap and an expansion tank are installed (at least 4% of hot water
volume in the manifold) to eliminate reverse pressure shocks.
Both the electric and water installation must follow and meet the requirements
and regulations relevant in the country of use!
4.2 TRANSPORT & STORAGE INSTRUCTIONS
The device shall be transported and stored in dry place and protected from weather effects with temperature
range from -15 to +50°C. During loading and unloading the instructions stated on the packaging shall be
observed.
4.3 DISPOSAL OF PACKAGING MATERIAL AND NON-
FUNCTIONING PRODUCT
The packaging that the product was delivered in has been paid for in form of
a service fee for the provision of the return and recovery. The packaging that
the product was delivered in has been paid for in form of a service fee for
the provision of the return and recovery. Take the water heater packaging
to a waste disposal place determined by the municipality. Disassemble
the discarded and unserviceable product after the operation terminates,
and transport it to a waste recycling centre (collecting yard), or contact
the manufacturer.
5 PRODUCT ACCESSORIES
The product is supplied together with a safety valve. Safety valve is packed and placed in the upper section
of the heater's packaging.
It is in your own interest to check the completeness of the accessories.
2-10-2018
- 15 -
Advertisement
Table of Contents
