Raymarine AIS700 Installation Instructions Manual page 43

With the proAIS2 software open on your PC:
1. Select the AIS device from the drop down list at the top of the page.
2. Click Connect.
3. Enter your vessel's details, including MMSI in the relevant fields.
4. Select a Vessel Type appropriate for your vessel from the drop down list.
5. Ensure that the built-in GNSS receiver is not outputting sentences (i.e. ensure GGA, GLL and
RMC boxes are not ticked).
The GNSS receiver built-in to the AIS700 is intended to provide GNSS data to the AIS unit only,
outputting this data can cause data conflicts. The ability to output these sentences is intended for
diagnostics purposes only.
6. Enter your vessel's dimensions and GNSS antenna location in the relevant fields.
7. If required set the baud rate for your NMEA 0183 ports.
8. Click Write Configuration to save your configuration settings.
9. Click Disconnect.
Set up
43