Honeywell VisionPRO Series User Manual page 12

Initiating occupancy mode: commercial use
This feature keeps temperature at an
energy-saving level until you touch Press
HERE to Start Occupancy. When you
arrive, touch the message to maintain a
comfortable temperature while the room is
occupied.
Touch the or
s t
temperature or the Hold Until time. The
temperature is maintained until the time
you set. Temperature returns to an energy-
saving level after the timer expires, or the
"Occupied" period ends.
NOTE: This feature is available only
when programmed by the installer.
Remote setback (commercial use)
During Occupied program periods, an occupancy sensor directs the thermostat
to go to REMOTE SETBACK settings when the room is empty. If someone is in
the room, it uses the Occupied program period settings. The thermostat ignores
the occupancy sensor during Unoccupied program periods.
If the thermostat is set up to be non-programmable, the sensor directs the
thermostat to go to REMOTE SETBACK settings when the room is empty. If
someone is in the room, then it follows the settings set by the user.
Depending on how your thermostat was installed, it may delay for up to 30
minutes before switching to REMOTE SETBACK settings. This delay allows the
room to stay comfortable if the room is unoccupied for only a short time.
69-2761EFS—03
buttons to set the
10
Press HERE to
Start Occupancy
M34127