Adding Th Ingridients In Manual And Auto Mode; Starting Operations In Auto Mode - Breville Smart Scoop BCI600 Instruction Book

ADDING THE INGREDIENTS
IN MANUAL AND AUTO MODE
TIPS
When using the ice cream machine always
insert the paddle before adding ingredients
into the bowl. Always add ingredients into the
bowl before inserting into the clean and dry
bowl chamber.
1. Ensure that the paddle and bowl, and bowl
chamber are clean.
2. Add ingredients to the ice cream bowl as
specified in the recipes. Wipe any spilled
ingredients from the rim of the bowl.
3. Insert the bowl into the bowl chamber by
pressing down firmly on the rim of the bowl
until it is securely in position, ensuring bowl
handle hinges sit inside grooves on the
chamber. It is important that the ice cream
bowl is properly assembled onto the drive
shaft to ensure that the paddle operates
correctly.
4. Align the hole in the bottom of the paddle
with the drive shaft in the bowl. Push down
firmly and secure into place.
5. It is important that the paddle is properly
assembled onto the drive shaft to ensure
that ingredients are churned properly.
6. Place the lid onto the ice cream bowl. It is
not recommended to open the lid during
operation unless stated in the recipe or if
mix ins are required.
7. To change the temperature reading from
C to F press the
8. Press volume button to select from high,
low, music or mute.
14
button.
STARTING OPERATIONS IN
AUTO MODE
1. To start making the dessert in auto mode,
press START | PAUSE.
2. Once you press START | PAUSE all of
the indicators on the selection bar will
disappear and ONLY the selected dessert/
consistency indicator will remain.
3. As the dessert starts to freeze the indicators
on the selection bar will display and scroll
up the selection bar to the chosen dessert.
The LCD screen will toggle between the
elapsed churning time and the current
temperature that the machine is chilling,
'KEEP COOL' and 'COOLING' will
illuminate. An indicator will sit above the
selected hardness setting.
4. If the START | PAUSE button is pressed
during the cycle this will pause the time.
To resume the process press the button
again. If you need to reset the timer press
and hold the START | PAUSE button for
2 seconds and this will reset the selection.
5. When the desired setting has been reached
the compressor and motor will stop. READY
will illuminate and REMOVE BLADE
will flash on the LCD display. The chosen
indicator will sound to alert the user that the
dessert is ready.
NOTE
• It could take up to 60 minutes for the
indicators on the selection bar to start
moving up on the LCD display.