Nikon Autofocus Speedlight SB-22 Instruction Manual page 44

SETTII{G POWER SWITCH
With other cameras:
Though the ON position is normally recommended for
turning on the flash unit, STBY can also be used.
With othe.r Nikon cameras, even if the camera's expo-
sure meter stays on, the SB-22 automatically turns off
when not used for one or two minules. To turn on
again, set power switch to ON or OFF position, then
reset to STBY. For convenience, you may also push
the ooen-flash button to turn on the SB-22
ON Position
W f t h c a m e r a s o t h e r t h a n t h e N l k o n F 4 ,
F-801/N8008, F-501 |N2O2O, F-401s/N4004s,
F-301/N2000, FA, FE2 and FG:
This position is normally used to turn on the SB-22.
With the Nikon FA,FEz, and FG:
To turn on the SB-22 when using mechanical shutter
settings (M250, M90 or B), set power switch to ON.
OFF Position
When not using the flash unit, a/ways set the power
switch to OFF oosition.
STBY (STAN DBY) Position
Use to conserve energy and shorten recycling time.
Wfth Nikon F4, F-801/N8008, F-501/N2020,
F-401s/N4004s, F-301/N2000, FA,FE2 and FG:
Use the SB-22's STBY oosition to turn on the SB-22.
In STBY position, when the camera's meter turns off, in
one or two minutes the SB-22 turns off automatically.
To turn the SB-22 on again, lightly press the camera's
shutter release button.
Note: When the Nikon FA or FE2 is connected to Nikon
Motor Drive MD-l2 via a remote cord, the camera's meter
stavs on and the SB-22 remains on at STBY position
43