Table of Contents
Advertisement
Station Setup - Setting up the 2400-A16-SD-NET for Logging.
Add the station to the Station programmer: click
Note: You must add the station to the memory of the software so the station Input Ranges and Memory Pages & Lines
setup can be completed.
If an SD card is not fitted to the station the following will be displayed (when the station programming info is read out)
Station Programmer SD Recording Options.
NOTES:
The record rate should be chosen to suit the rate required. The rate selected also determines how existing store
data is displayed in the same manner as store data is read from MicroScan data files in MicroScan.
Changing the recording rate is not recommended, the pages and lines screen displays data at the current record
rate. Therefore any data before the change will be displayed at incorrect frequencies.
'Clear Station Memory' and 'Set ReadPtr = WritePtr' are both engineering test settings.
Diagnostics: For normal operation, the 'Number of Samples' will be 7858811, 'Write Pointer' will be a non zero
value and SD status = '81 OK'.
In this area you can setup the station's input/output type
and configurations. Further information can be found in
the 2400-A16 Installation Guide.
A 2400-A16 with SD software will be shown in the lower
info panel: A16 SW Ver = 6.15,0.05. 0.05 = SD version.
The SD Recording button will also be shown. Click this
to load the 'SD Recording' window.
Storage Mode.
Default setting is to 'Cyclic Memory', which is set to
overwrite the oldest samples when the SD Card is full.
Recording Rate.
Select the Record Rate from the drop down menu.
(e.g. Scan all channels every 5 seconds.)
Duration Details are calculated automatically based on
the chosen Record Rate.
Station Clock.
To program current computer time to the station, tick the
'Set Clock On Station Program' box.
To finish click 'OK', then click 'Program' to save the
settings to the 2400-A16-SD-NET station.
8
:
Advertisement
Table of Contents
