Description; Features; Quick Overview Of Using The 2400-A16-Sd-Net Logger - Intech Micro 2400-A16-SD-NET Installation Manual

Intech Micro
2400-A
16-SD-NET

Description.

The SD version of the 2400-A16 is a great way to achieve a stand-alone
method for data logging. The station can be used as a 16 input stand-alone
logger, or as part of a SCADA data high way with backup logging facility.
The user friendly, free to download Intech Micro Station Programmer
software (version 5.2.3613.5 or later), supports the reading of SD cards on
the 2400-A16-SD-NET.

Features.

 Logging of Analogue Inputs 1~16, Digital Inputs 1~4 and Ambient Sensor onto an SD Card.
 Up to 7858811 Data Samples.
 Data Store Rates Selectable From 1sec ~ 60min.
 Cyclic or Stop Modes when SD Card is Full.
 Internal Real Time Clock with Battery Backup.
 Read SD Memory Card by removing SD Card and Reading from a Computer SD Port, or using Comms.
 16 Isolated Universal Analogue Inputs, with Plug In Terminals.
 Each Input Individually Selected & Scaled.
 Four Dedicated Digital, Isolated, Optocoupler Inputs.
 Two Analogue, Isolated, 4~20mA Outputs.
 Two Digital, Isolated, Relay Outputs.
 Comms Ports (also note the protocol information listed below):
 Port 1: Isolated Ethernet TCP/IP.
 Port 2: Isolated RS232/RS485.
 Port 3: USB programming port via XU-USB programming key.
 Embedded protocols, Auto Detecting:
 MicroScan ASCII.
 Modbus RTU.
 Modbus TCP.
 Easy Programming and Memory Viewing etc using Intech Micro Station Programmer software.
 Universal AC/DC Power Supply (three options to select from):
 H = 85~265Vac, 95~370Vdc. (Standard)
 M = 24~48Vac, 17~72Vdc.
 L = 10~30Vdc.
 Compact 35mm DIN Rail Mounting.
 Easy to Install.
 Low Cost.

Quick Overview of using the 2400-A16-SD-NET Logger.

1. Station Setup:
Configure the 2400-A16-SD-NET station with Input types as required.
Configure the 2400-A16-SD-NET station's SD recording parameters.
2. SD Card Setup:
Configure the Pages & Lines for all Inputs being used.
Initialise SD card if more than one computer is used for download.
3. Record:
Insert the SD card into the 2400-16-SD-NET's SD slot, you will hear the latch on the SD socket 'click'.
The RECORD LED will flash while the log file is created. Once logging has started, the RECORD LED will stay on.
If the log file is already there, the 2400-A16-SD-NET will use that and the RECORD LED will come on straight away.
4. Download:
Using either an SD port on the computer or the 2400-A16-SD-NET's Comms, all new data is downloaded into the
Station Programmer software and stored in a log file.
3
SD Memory Logging.
16 Universal Analogue Inputs.
4 Dedicated Digital Inputs.
2 Analogue 4~20mA Outputs.
2 Relay Outputs.