Hydraulic System Priming - Grizzly T1242 Owner's Manual

4. Turn master power switch to "I" position (see
Figure 12). Power lamp will illuminate when
machine is receiving power.
POWER LAMP
WORK LAMP
EMERGENCY
STOP Button
Figure 12. Control panel components.
5. Twist EMERGENCY STOP Button clockwise
until it springs out (see Figure 13).
Figure 13. Resetting the EMERGENCY STOP
Button.
6. Press START button to turn motor ON.
WORK LAMP light will illuminate when motor
is running. Verify motor starts up and runs
smoothly without any problems or noises.
7. Press EMERGENCY STOP button to turn
machine OFF.
8. WITHOUT resetting EMERGENCY STOP
Button, start machine by pressing the START
button.
— If machine does not start, EMERGENCY
STOP Button is working correctly. Test
Run is complete.
— If machine does start, immediately
turn it OFF and disconnect power. The
EMERGENCY STOP safety feature is
NOT working properly. This safety feature
must work properly before proceeding with
regular operations.
Model T1242 (Mfd. Since 04/18)
Master Power Switch
START
Button
STOP
Button
Hydraulic System
Priming
To prime the hydraulic system:
1. Turn machine ON.
2. Fully extend, then retract ram using ram con-
trol lever (see Figure 14).
3. Repeat Step 2.
4.
DISCONNECT MACHINE FROM POWER!
5.
Check hydraulic tank fluid level.
—If fluid level is still at fill mark continue to
next step.
—If fluid level is below fill mark add hydraulic
fluid (see Page 16).
6. Repeat Step 2.
A
Tank
B
Sight Glass
Figure 14. Location of ram control lever and
sight glass.
Ram Control Lever
Fill Cap
Sight Glass
Fill Mark
-17-