Grizzly T10827 Instructions

For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com

Introduction

The Model T10827 Industrial Heat Gun provides
a flow of heated air for applications such as paint
stripping, bending and molding plastics, shrink
wrapping, and drying adhesives. The adjustable
stand supports the heat gun, allowing both hands
to hold the workpiece in the hot airflow. Read all
instructions and safety material before operating
the heat gun.
Air Intake
Shutter
Figure 1. Model T10827 controls and major
components.

Specifications

Power Requirement .. 120V, Single-Phase, 60 Hz
Full-Load Amp Draw ................................... 12.5A
Minimum Circuit Size ..................................... 15A
Temperature Range ...................... 122°F–1022°F
Cord ............................................................... 6 ft.
Plug ................................................... NEMA 5-15
Weight ..................................................... 3
COPYRIGHT © NOVEMBER, 2014 BY GRIZZLY INDUSTRIAL, INC. REVISED MARCH, 2021 (BL)
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
Rocker
Switch
Stand
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
#WK16758 PRINTED IN CHINA
INDUSTRIAL HEAT GUN

Operation

To adjust the amount of heat applied to your work-
piece, adjust the air intake shutter, the distance
between the nozzle opening and the workpiece,
and the length of time heat is applied to the work-
piece.
To operate heat gun:
1. Make sure rocker switch (see Figure 1) is set
to OFF.
2. If using adjustable stand, thread stand into
one of three mounting holes on heat gun
body.
3. Adjust air intake shutter (see Figure 1) to
desired position. Opening shutter provides
slightly cooler air. Closing shutter provides
the highest temperature.
4.
Plug heat gun into power supply.
5.
Move rocker switch to HOT position, and wait
approximately 2 minutes for it to reach oper-
ating temperature before beginning heating
operation.
6. When finished with heating operation, move
switch to COLD position and allow heat gun
to run for 2–3 minutes to cool off.
7.
Move rocker switch to OFF position.
⁄ lbs.
1
2
MODEL T10827
INSTRUCTIONS
V1.03.21