Advertisement
RWM 2 • Installation Guide (Continued)
1
RWM 2
Installing a TLP Pro 725M with the RWM 2
Figure 2.
Before You Start
Decide where you want to mount the touchpanel. A cut-out template for the RWM 2 is available at
provides dimensions of all the components to be installed.
Use the template to cut a hole in the drywall (see
1.
The RWM 2 is suitable for drywall that is 0.50" to 1.00'' (12.7 mm to 25.4 mm) thick.
Route cables to the hole.
2.
If local building codes require cables to be run through conduit to a junction box, then the RWM 2 can be used with a standard
2-gang EU junction box, 1-gang MK junction box, or a horizontally mounted 1-gang North America junction box, (Extron JB 125).
The junction box must be purchased separately.
Both the TLP Pro 725M and 1025M include #6-32 screws and M3.5 screws.
•
Mounting the RWM 2 Directly to Drywall
Run a PoE/Ethernet cable through the RWM 2.
1.
Ensure the locking arms (
2.
Use a Philips-head screwdriver to turn and tighten the locking arms. The locking arms will hold the RWM 2 securely, but
3.
should not be over-tightened.
Mounting a TLP Pro Touchpanel
The touchpanel mounting plate has four hooks (
1.
fit into touchpanel's two rear slots (see the TLP Pro 525, 725, and 1025 Series User Guide).
Slide the TLP Pro 725M or 1025M down slightly, so the hooks are secure in the slots.
2.
The tongue at the bottom of the mounting plate (
3.
touchpanel to the mounting plate by tightening the lock screw (
After the TLP Pro touchpanel has been assembled, connect the ethernet cable to the rear port on the touchpanel (see the
4.
TLP Pro 525, 725, and 1025 Series User Guide)
Place the touchpanel against the RWM 2. Strong magnets on the RWM 2 hold the touchpanel in place.
5.
© 2018 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
2
2
RWM 2
figure
2
) are lying flat against the top and bottom of the RWM 2, and insert it into the hole.
3
) one on each corner. Position the TLP Pro 725M or 1025M, so the hooks
4
) sits in the groove at the bottom of the touchpanel (
Touchpanel
Mounting
Plate
5
Back View
6
Lock Screw
2,
1
) that is 4.29" H x 6.14" W (109 mm H x 156 mm W).
6
).
3
4
TLP Pro 725M
www.extron.com
and
5
). Fasten the
www.extron.com
68-3235-01 Rev. B
06 18
Advertisement
