Table of Contents
Advertisement
1.7.3 Instruction manual
The Model 7013 Instruction Manual is three-hole
drilled so that it can be added to the three-ring binder
of the Model 7001 Instruction Manual. After removing
the plastic wrapping, place the manual in the binder
following the mainframe instruction manual. Note that
a manual identification tab is included and should pre-
cede the switch card instruction manual.
If an additional instruction manual is required, order
the manual package, Keithley part number 7013-901-
00. The manual package includes an instruction man-
ual and any pertinent addenda
1.8
Repacking for shipment
Should it become necessary to return the Model 7013
for repair, carefully pack the unit in its original packing
carton or the equivalent, and include the following
information:
•
Advise as to the warranty status of the switch card.
•
Write ATTENTION REPAIR DEPARTMENT on
the shipping label.
•
Fill out and include the service form located at the
back of this manual.
1.9
Optional accessories
The following accessories are available for use with the
Model 7013:
Model 7013-ST This screw terminal connector card
is identical to the one provided with the Model 7013-S
assembly. An extra screw terminal connector card
allows you to wire a second test system without dis-
turbing the wiring configuration of the first connector
card.
Model 7011-KIT-R This connection kit includes a
96-pin female DIN connector that will mate directly to
the connector on the Model 7013-C or to a standard
96-pin male DIN bulkhead connector (see Model 7011-
MTR). This connector uses solder cups for connections
to external circuitry. It includes an adapter for a round
cable and the housing.
Model 7011-MTC-2 This two-meter round cable
assembly is terminated with a 96-pin female DIN con-
nector on each end. It will mate directly to the connec-
tor on the Model 7013-C and to a standard 96-pin male
DIN bulkhead connector (see Model 7011-MTR).
Model 7011-MTR This 96-pin male DIN bulkhead
connector uses solder cups for connections to external
circuitry. It will mate to the Model 7011-KIT-R connec-
tor, and Model 7011-MTC-2 cable assembly.
General Information
1-3
Advertisement
Table of Contents
