Front Panel; Rear Panel - Ace Plus EX-G013A User Manual

ACE PLUS CORP.
1
Set pin#2-ON [ ] firstly and then connect the HDMI Input to HDMI display through HDMI
cable. Waiting for 20 seconds, the learning procedure will be accomplished. When update
the EDID content with another display, you must set pin#2-OFF[ ] and repeat this
procedure again.
2
Set pin#3-ON [ ] firstly and then connect the HDMI Input to HDMI display through HDMI
cable. Waiting for 20 seconds, the learning procedure will be accomplished. When update
the EDID content with another display, you must set pin 3 off and repeat this procedure
again
3
While 7.1 channel option is selected for the HDMI signal with only stereo audio, the
HDMI display may show video without audio. In this case, please set audio to stereo
audio.
EX-G016
2x8 HDMI over Single CAT5 Cascading Distribution
Amplifier

Front Panel

1 2
1. 1.2a/1.3a: Output format LED indicator [Green: HDMI 1.3 / Red: HDMI 1.2]
2. Format Sel: Push button for HDMI output format selection
3. IN 1/IN 2: Input LED indicator [Green: HDMI input / Red: RJ-45 input]
4. IN Sel: Push button for input HDMI source selection

Rear Panel

5 6 7
Page 11 of 18
8 9 10
3
Headquarters :
9F-2., No. 190 Sec. 2 Jung Shing Rd.,Hsin-dian,
Taipei, Taiwan 231
TEL: +886-2-2912-4201
FAX: +886-2-2912-3164
Website: www.ace-plus.com
4
11 12