Table of Contents
Advertisement
DTS
If your A/V receiver is equipped with a DTS decoder,
your DVD-VCR can output DTS digital sound, but you
MUST enable this feature in the menu system.
NOTE: Select "On" ONLY if you have connected a
DTS-equipped A/V receiver to the Digital audio
Out (coaxial) on the DVD-VCR rear panel.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
3 Select "Audio"
Highlight "Audio", then press the ENTER button.
4 Set "DTS"
Highlight "DTS" then press the RIGHT button to
select one of the following options:
• Off – To use your DVD/TV with an A/V receiver
NOT equipped with a DTS decoder.
• On – To use your DVD/TV with an A/V receiver
equipped with a DTS decoder
PCM Down Sampling
: On
Dynamic Compression restrains the dynamic range of
sounds, i.e. the difference between the loud and quiet
passages of a DVD audio track.
1 Open "MENU"
2 Select "DVD"
3 Select "Audio"
4 Set "Dynamic Compression"
Off
PCM Down Sampling
On
ENG-18
Dynamic Compression
Press the MENU button while the DVD is in Stop
mode.
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
Highlight "Audio", then press the ENTER button.
Highlight "Dynamic Compression", then press the
RIGHT button to select one of the following options:
• On – This will compress the total dynamic range
of the DVD audio, making quiet passages
in the audio signal louder and loud
passages softer.
• Off – This will preserve the original dynamic
range.
On
On
Off
: On
On
Off
Advertisement
Table of Contents
