Digital Output; Dts - Samsung DVD-V540 Instruction Manual

Digital Output

If your A/V receiver is equipped with a Dolby Digital
decoder, your DVD-VCR can output Dolby Digital 5.1
sound, but you MUST enable this feature in the menu
system to prevent damage to your speakers.
NOTE: Select "Bitstream" ONLY if you have connected
a Dolby Digital-equipped A/V receiver to the
Digital Output (coaxial) on the DVD-VCR rear
panel.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
3 Select "Audio"
Highlight "Audio", then press the ENTER button.
4 Set "Digital Output"
Highlight "Digital Output" then press the RIGHT
button to select one of the following options:
• PCM – To use your DVD with an A/V
receiver without a Dolby Digital
decoder.
• Bitstream –To use your DVD with an A/V
receiver with a Dolby Digital decoder.
PCM Down Sampling : On
If your A/V receiver is equipped with a DTS decoder,
your DVD-VCR can output DTS digital sound, but you
MUST enable this feature in the menu system.
NOTE: Select "On" ONLY if you have connected a
1 Open "MENU"
2 Select "DVD"
3 Select "Audio"
4 Set "DTS"
PCM
Bitstream
ENG-18

DTS

DTS-equipped A/V receiver to the Digital audio
Out (coaxial) on the DVD-VCR rear panel.
Press the MENU button while the DVD is in Stop
mode.
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
Highlight "Audio", then press the ENTER button.
Highlight "DTS" then press the RIGHT button to
select one of the following options:
• Off – To use your DVD with an A/V receiver
NOT equipped with a DTS decoder.
• On – To use your DVD with an A/V receiver
equipped with a DTS decoder
PCM Down Sampling : On
Off
On