Tailwind iQ3 User Manual page 6

STEP 2: SELECT MOUNTING LOCATION FOR:
A: THE CONTROL MODULE
IMPORTANT:
• ENSURE THE POWER ADAPTER WILL REACH THE UNIT WHEN PLUGGED IN
• DO NOT PERMANENTLY MOUNT THE MODULE WITH TAPE UNTIL THE VERY END
FOR 1 DOOR = LOCATE THE MODULE ON THE SIDE OF DOOR OPENER
FOR 2 DOORS = LOCATE THE MODULE ON THE SIDE OF EITHER DOOR OPENER
FOR 3 DOORS = LOCATE THE MODULE ON THE SIDE OF THE DOOR
OPENER THAT CONTROLS THE MIDDLE DOOR
B: THE DOOR SWITCH & MAGNET
1. CHOOSE SIDE OPPOSITE TO THE DOOR LATCH IF ONE IS PRESENT
2. DO NOT INSTALL NEAR LOWER PHOTO SENSORS
3. ROLL THE GARAGE DOOR UP AND DOWN TO MAKE SURE THAT
NOTHING WILL INTERFERE WITH THE DOOR SWITCH AND
MAGNET AS THE DOOR MOVES
STEP 3 - MOUNTING THE DOOR SWITCH
ENSURE BOTH PARTS CLOSELY ALIGN WHEN THE
DOOR IS CLOSED
1. MOUNT THE SWITCH BRACKET ONTO THE GARAGE DOOR FRAME OPENING
2. MOUNT THE MAGNET BRACKET ONTO THE EDGE OF THE GARAGE DOOR
IMPORTANT: YOU CAN ADJUST THE MOUNTING POSITION OF THE MAGNET
BRACKET USING THE SINGLE SCREW AND THE 2 SCREW HOLES PROVIDED
MAGNET BRACKET
6 NEED HELP?
WWW.GOTAILWIND.COM/INSTALLATION
TAILWIND iQ3 USER MANUAL
< 3/4"
GAP
SWITCH BRACKET